PMP Arcos

S-600/S-601 HYDRAULIC SHOWER OSCILLATOR

Thu, 22 May 2014 07:55:00 GMT

S601
Hydraulic Shower Pipe Oscillator
Long life span, reliable, no motor that wears down, low
maintenance, constant speed in both directions and change of
direction without delay are some of the characteristics forArcos
S601
The oscillator consists of two sections: the mechanical oscillation
cylinder, complete with valve package and electric control unit,
which is to be placed in an electric cabinet. The electric control unit
can be connected to a process computer, or it can be controlled
directly e.g. from a control desk.

ELECTROMECHANICAL SHOWER OSCILLATOR（S-700/S-701）

Thu, 22 May 2014 07:50:00 GMT

S700
Electromechanical Shower Pipe Oscillator
Low frequency stateoftheart
electromechanical oscillator,
mechanically compatible with Arcos's hydraulic oscillator.
Motion is controlled and monitored by an intelligent and very
compact electronic system. Can be controlled by PLC or manual
panel. Inputs for start/stop and speed. Feedback outputs for speed,
OK/fault, run and home position. Run output can be used for
controlling water valve. Stroke easily set in mm:s or inches. All
functions can be monitored on the LED panel.
Supplied either with separate control modules or built in cabinets
with power supply and control panel.

S-750 ELECTROMECHANICAL SHOWER OSCILLATOR

Thu, 22 May 2014 07:44:00 GMT

S750
Electromechanical Shower Pipe Oscillator
Low frequency stateoftheart
electromechanical
oscillator for
high temperature applications
Motion is controlled and monitored by an intelligent and very
compact electronic system. Can be controlled by PLC or manual
panel. Inputs for start/stop and speed. Feedback outputs for speed,
OK/fault, run and home position. Run output can be used for
controlling water valve. Stroke easily set in mm:s or inches. All
functions can be monitored on the LED panel. Supplied either with
separate control modules or built in cabinets with power supply and
control panel.

S-520/520A PNEUMATIC DOCTOR OSCILLATOR FOR WET END

Thu, 22 May 2014 07:39:00 GMT

Long life span, high reliability, no engine that wears, no maintenance, are some of the characteristics for S520.

The oscillator is mainly an stainless steel cylinder (316L). The valve controlling the oscillating functionsis mounted in the cap, sealed from water by a stainless steel casing. The oscillating speed is easily adjusted with a screw, situated under a plug in the casting .
* S520 is designed especially for oscillation of doctors in, for example, wire and press section.
* S520 is designed so that it can replace existing “Valmetstyle”
oscillators without
any other fastening devices.
* S520 is standard built with 1620mm adjustable stroke length but is available with other stroke lengths.
* S520 moves smoothly and has variably speed.
* S520 is connected with one hose to a compressed air system with clean air.

DATA:
* Cylinder diameter 160mm.
* Recommended pneumatic pressure
6 bar.
* Pulling force at 6 bar 11000 N.
* Speed 315
strokes/min.
* Temperature max 150°C
* Stroke length specified by order
(16mm standard)
* Air Clean air.
* Weight 27 Kg.

S - 571 wet end hydraulic proofreading oscillator

Thu, 22 May 2014 07:34:00 GMT

Used for conductor, pressure equipment S - 571 type oscillator

With high reliability, long service life, no dynamic wear and tear, no maintenance and maintenance, etc.

Oscillator subject for stainless steel cylinder, the function of the valve controlled oscillator in a sealed waterproof stainless steel enclosure.

S - 571 type design for double checked oscillator.

Data:

Can connect directly to the hydraulic system

Speed: 3-15 stroke per minute

Temperature: 70 degrees Celsius

Material: 316 L (SS2343)

The piston rod end reinforcement. (maximum pressure load: 140 bar = 140 N)

Three-way spray drying of fabric filter

Thu, 22 May 2014 07:24:00 GMT

Three-way spray drying of fabric filter

Three-way spray drying fabric purifier specially designed to clean and dry, apply to all of the paper machine.

Purifier includes three sprinkler, steam spray device, high pressure water spray and air spray device. The spray oscillator by the support bar resonance. Oscillator for ARCOS modified electric generator, high temperature resistance.

In production, three-way jet air purifier with steam and (or). Water net function can only be used in equipment suspended or closed.

A unit of dry clean cloth time at least 1 minute 30 seconds, in this time dry fabric washing time for 1 time. Clean the length according to water consumption decision.

Data:

Water consumption: 22 l/min/m width;

HP hydraulic: biggest: 35 bar;

Air usage: 0.27 m3 / min/m width

Pneumatic: about 6 bar

Water usage: 39 kg/h/m width

Vapor pressure: 2.5 bar

Place in the top fabric with saving device.

S - 800 automatic brush drive

Thu, 22 May 2014 07:22:00 GMT

S - 800 automatic cleaning nozzle

Jetbrush (spray cleaning brush) is specially designed for nozzle cleaning, when artificial have difficulty in cleaning or washing, performed by Jetbrush.

Jetbrush combined with manual product, easy to remove, namely: the flush valve by manual when maintenance cleaning spray device. Cleaning intervals can choose between 1-15 hours. The whole equipment simple structure, wear very little.

Data:

Equipment manufacture material for stainless steel (316 l) (SS2343);

The highest working temperature: 70 degrees Celsius;

Distance: 85 Nm;

1-9 stroke/cycle;

Safe low voltage (24 v)

Maximum current 3 a

Paper machine spray pipe

Thu, 22 May 2014 07:15:00 GMT

1, the oscillation spray pipe

Cleanmarc series spray tube includes a variety of pipe diameter and pressure level.

Cleanmarc bearing will not affect work with sundry pollutants of sensitivity.

The sprinkler can be placed in the different position in the work piece.

To make sure that the edge of the range of cleaning effect, the nozzle is more short, the distance between the end of the nozzle.

Data:

Tube size:,60,70,89,106,140 54 and 158 mm;

Maximum pressure: 35 bar;

Spray device can put location: left, right, top, bottom, central axis

Roller bearings: take directional sliding vane

Nozzle: select material: stainless steel, ceramic, ruby, or optional according to customer requirements;

Stainless steel or plastic brush

2, the full range of low pressure spray pipe

Cleanmarc manufacturing more than 4000 pieces of sprinkler, has the rich experience, to ensure product quality.

Low pressure sprinkler need precision design to ensure that can work normally.

Sprinkler is divided into two kinds, configuration inside cleaning brush, or is not configured. If the component in the design structure increase the flush valve, can install after cleaning brush.

Automatic cleaning brush, to choose and buy, used for artificial clean difficult or impossible to clean the place.

Data:

Tube size:,60,70,89,106,140 54 and 158 mm;

Maximum pressure: 35 bar;

Nozzle material: stainless steel, ceramic, ruby, or according to customer's requirements:

Can be configured or not configured cleaning brush, cleaning brush optional stainless steel or plastic material, also optional automatic cleaning brush.